Equipment Rentals For Sale Contact Us


Eagle One

20” CS Dredge

HS Truman

18” CS Dredge


12” CS Dredge


12″ SWL Dredge


12” SWL Dredge


12” SWL Dredge


12” Auger Dredge


10” Auger Dredge


8” SWL Dredge

Dino 6

6” Auger Dredge

Equipment For Sale

Dredge America, Inc. provides access to used dredging equipment, new dredge equipment, and dredges for rent. If you are interested in any of the following dredge equipment or would like to speak to us further about your dredging equipment needs, please contact Dredge America at 800-464-5597 or email us at


The Eagle 1 is custom built 20″x18″ cutter suction dredge built by CDW (Custom Dredge Works). This dredge is ideal for inland lakes and river maintenance dredging projects. Coupled with an idler barge this dredge is almost 200′ long and has the ability to reach extremely high production rates. It is equipped with state of the art dredge operating systems, flow monitoring, density monitoring, and onboard cameras. The idler barge is over 80′ long and includes a carriage spud system with a 12′ stroke. This unique setup allows for maximum dredge efficiency and optimal production. The dredge itself is portable and takes 7 loads to move from site to site. The basic equipment specs can be obtained by contacting Dredge America directly.

Dredge America Eagle One 2


A recent trend in the dredging industry is to pump low flow rates with higher percentage solids and the Moray follows this tendency with its hydraulically driven underwater pump assembly. It has also been successfully used where flow rates need to be minimized to pump into geo-tubes or retention areas that do not allow for large volumes of water. The dredge is equipped with an 8″x 8″ submersible pump, has a 19′ swing in its swinging ladder configuration, and is single truck transportable. More information can be obtained by contacting Dredge America.

Dredge America - Moray 2


Dredge America has a vast array of HDPE pipe for sale. This includes roughly 5,000 linear feet of 12″ pipe, 3,000 linear feet of 8″ pipe, 5,000 linear feet of 20” pipe, and 5,000 linear feet of 22” pipe. All pipe is in good condition with flanges and back-up rings available separately.

Dredge America - 12 Inch Pipe


These custom steel barges are a 2 part set that connect together using a simple and convenient pin system. The barges are ideal for use on mechanical dredging projects as can be seen in the photo below. The setup comes with the barges, a hydraulic spud system, and two spuds. Crane mats, barge hoppers, and long reach excavator are sold separately. Barges are 60’x12’x5′ with a load capacity of 200,000 lb with 2′ of freeboard.

Dredge America - Barge

Dredge America © All Rights Reserved.2017